Products
New Clip Design
If you purchased a Mirrix Loom in the spring of 2015 or later, you may have slightly different wooden clips on your loom than the ones we show in our instructions and promotional material.
Following is all you need to know about the new clips!
First, the new clips have wing-nuts to hold the brass disks to the clip instead of screws. This means you will not need a screwdriver when putting on your shedding device.
Second, the white plastic screw that holds your wooden clips to your loom can now slide from the side (perfect for storage and shipping so the screw does’t break) to the back. Make sure to slide the screw to the back before tightening the clip to your loom.
6 Comments
dr.lynnsomerstein@gmail.com
thanks- info + elbow grease does it!
Barbara sales
A short description and picture included with the loom would have solved the the problem right away. I didn’t have a clue until I sent an email. It makes perfect sense now.
Judy Buchanan
That requirement to change the orientation of the white plastic screw should be included in with the loom! Finding this info has been very frustrating. It may be obvious to someone familiar with the loom, but not a beginner.
mirrixlooms
Sorry for the confusion, Judy. We do have this information at the top of our warping instruction page and will switch to new printed instructions soon.
sterndesignc
Since i am buying a new loom — the Zeus — and the stand and power treadle, do i need to purchase another set of wooden clips?
mirrixlooms
Nope. You just need wooden clips if you have an old loom without wooden clips.