I my last blog post, I talked about two projects that I rally want to loom, and how I couldn’t choose which to do first. Someone then suggested I could get them both on the loom. There are two options for this. Firstly, I could loom one, then advance the completed weaving and then loom the other. secondly, I could warp as usual and push the warping bar all the way down. Then I would be free to use both sides of the loom simultaneously. The latter sounded more like what would be the suitable method.
Now, the two projects are 152 and 162 beads wide. I don’t want to jump in at the deep end, as it’s crucial for me to get them absolutely right. With that in mind, I decided to try out this way of using the loom before proceeding with the portrait and purse. I warped as usual, then pushed the warping bar as far down as I could. It doesn’t quite fit underneath the loom so it juts out slightly at an angle.
I encountered no problems in warping and moving the warping bar. I then loomed two rows at top and bottom of the warps for the (two) projects that would go on the back. There was no need to do this for the front project, as the coil was enough to space the warps. I did add a line of beads on the front of the bottom bar, but found I couldn’t quite place the warps in it once I had moved the warping bar downwards. However, this can be very effective in spacing the warps towards the bottom of the loom, if you don’t have the bottom spring kit. Thank you to the person who suggested it to me (you know who you are).
As you can see I am able to work on three projects at the same time. Without the extra warping bar kit, a substantial amount of warping thread is used for warping. This is one way to reduce this warp wastage, as long as the warp colour chosen matches what you plan to loom. So, a little forward planning helps. As I often like to (or inevitably) work on several projects, this makes things easier for me – I don’t have to keep swapping looms to work on each, and my thread doesn’t go to waste.
So, I think this could be something I use again in the future if I have multiple projects that can fit on the Mirrix at the same time. For now, I have the two bracelets at the back, and the front of a photo purse to complete. Some warp cutting is necessary for the bracelet on the left, but I may leave that till the front project is all loomed. I’ll make up my mind as I go along.
I’m off to nurse my cold and get some sleep. Hopefully I can do some more tomorrow evening. The purse (front) takes some time to set everything up – more than 26 colours need to be laid out on bead mats, in a particular order. It’s a little boring but needs must! Sweet beady dreams!