This blog post is part of a series on the basics of weaving tapestry
Tapestry is by definition weft-faced weaving. This means that you can see the weft (the fiber that you weave back and forth) and cannot see the warp (the fiber you wrap around your loom). To achieve this, a weaver must figure out the correct combination of warp spacing (this is called "sett"), warp size and weft size.
On a Mirrix, warp spacing is determined by the warp coil (or spring) at the top of the loom. We identify different warp coils by how many dents (the spaces between the coils) are in an inch. This is called DPI (dents per inch) or EPI (ends per inch). Choosing the correct warp coil for the warp and weft you are using is very important when planning your tapestry.
Generally speaking, if you are using a finer weft you will want to use a warp coil with more dents per inch and if you are a using a thicker weft, you will want to use a warp coil with fewer dents per inch or even warp every other dent (For example, an 18 dent warp coil every other dent is equal to a 9 dent warp coil.)
Unfortunately there is not a simple trick for figuring out your warp spacing. Every weft and warp combination is different and it might take some time to begin to get a sense of what warp coil should be used each time you weave a new piece.
A good way to determine if your sett is correct is to put your weft in between your warp threads vertically when your loom is warped. If your weft threads are much thicker than the space between the two warp threads, then your weft is probably too thick and if your weft threads are much thinner than you know your weft is too thin.
One way to choose your warp sett is to look at what sett others have used with the same warp and weft you are using. Check out some of our free projects and weave-alongs and look at the warp and weft and sett that we are using. Imitation is a good way to get started!
We also have a handy crowd-sourced list of different tapestry yarns people have used and the EPI/DPI they set their loom at.