This present bead looming is considered a ‘wide looming’, 67 beads wide, opposed to many pieces loomed by beaders. Cuffs can get wide, maybe even 40 beads wide (2 1/2″), but not as wide as this cell phone bag panel. This is a good time to reiterate how to deal with a ‘long wavy first row’.
I receive numerous emails, asking me this very question, “Is it OK that my first row is not laying straight?”. To answer this question, I will share some of my first few rows, on this cell phone bag panel. It may have been discussed before, here on my Blog or in my Website, but I feel it is worth discussing again.
Below is a picture of my first row, 67 beads wide, secured on the warps, as any other loomed row of beads. Notice how wavy this looks. This is exactly why some loom companies offer a loom they feel is created for ‘various types of beads’, (Czech, Delica, etc., but all 11/0). It’s the spacing of the ‘weft separator’ that we are told makes all the difference. I strongly disagree, with this assumption. I use the same loom, some width separators, for most of my loomings, (The only time I change up looms is to acquire a larger ‘loom table’, for larger pieces, sized larger then the loom.). If you start in the center of your loom, center of your pattern, any loom will work. The other option is to just ignore the wavy reaction, as I do here.
If you prefer to start out with a ‘straight row’ of bead looming, or feel you just are not sure it will work out as planned, then cut a length of 24 gauge craft wire. Thread this through the entire first row of beads. You can see in the picture below, it will straighten out the beads perfectly. Since you are not running your needle back through that row, then it can sit till you feel comfortable enough to pull it out, or if you need to remove it for your finishing techniques.
I feel comfortable keeping the row of beading as it is, without the wire support, especially for long rows. My hand is not wide enough to reach across the row, without rippling the beads, to run the needle through the rows that follow. Therefore, I can almost, ‘grab my long row of beads’ in my hand and release the row as my needle is threaded into the next row.
Now that I have completed 28 rows, of the pattern I created, the ‘wavy first row’ is no longer an issue! It gets even better, after the piece is cut from the loom!
The best advice is to make yourself feel comfortable about what you are looming. Use the wire technique if you feel you need to see a more uniform look, or just let it work itself out, as the rows increase. Looming takes a lot of ‘special time’ and the last thing anyone wants is to feel they have to cut the warps and start over!